Table of Contents
Advertisement
4. Enter the 'SERVICE MODE' and select 'Add-Ins'. Finally set CLO on 'INACTIVE'.
5. Loosen the lock nut (A), securing the adjustable screw (B) for the optical Z-axis adjustment.
Image 27-29
Optical alignment Z-axis
6. Carefully adjust the adjustable screw (B), using an Allen key of 3mm, for maximum light fall on the screen.
7. Lock the adjustable screw by fastening the lock nut (A).
8. Cancel the above modified projector settings (Step 2 to 4).
27.3.4.3 Reinstalling the Side Panel
What has to be done
After the new lamp unit has been installed, the side panel has to be remounted.
Necessary tools
A flatblade screwdriver of 5 mm
Reinstalling the side panel
1. Move the cover guides under the back cover and push the front of the cover against the projector frame lining up the cover lock
screw with the speed nut (A) on the frame.
Image 27-30
Mounting the side cover
2. Turn with a screwdriver the side panel lock screw (B) a quarter turn clockwise to lock.
R5976820 SLM R12+ PERFORMER 08/03/2005
Image 27-31
Closing the side cover
27. Maintenance
A
B
197
Advertisement
Table of Contents
