Barco SLM R12 Plus Service Manual page 192

27. Maintenance
6. Remove metal fixation bar from rear cover.
Both air filters (E) can be removed for cleaning or replacement.
Image 27-16
Air filter removal
How to clean!
1. Put the dirty air filter far away from the projector or preferable in another room.
2. Brush most of the dust off with a soft brush and/or blow dust away with compresses air.
Tip: Always replace damaged and/or too dirty air filters by a new one.
How to reinstall the cleaned or new air filter
1. Place the air filters (A) on their place in the projector rear cover.
Image 27-17
Mounting the fixation bar
2. Place the metal fixation bar (B) on its place, slide it to the left and secure by tightening the 3 socket screws (C).
3. Place the metal fixation plate (D) on its place, slide it to the left and secure by tightening the 6 socket screws (E).
Image 27-18
Mounting the fixation plate
4. Reinstall the rear cover onto the projector and secure by turning the captive screws (A) half a turn clockwise.
190
A
A
D
E
C
E
B
R5976820 SLM R12+ PERFORMER 08/03/2005
C
E