AGFA DRYSTAR 5302 5366 Service Manual page 84

DD+DIS150.05E
Hardware Component
Key 6 Board
Hard disk
CF drive
Thermal head
OSB board
Power supply
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
06-2009
Description
•
Controls the display with 122 (width) x 32
(height) pixels
•
Controls all buttons and LEDs required for
operation
•
Keeps the operating system, all application
software and diagnostic data
•
To save or install data via CF card type II
•
Transfers the diagnostic data (pixels) via
heating elements to the heat sensitive film
•
Switch board for the different TH heating
elements
•
Provides the power for heating up the resistor
elements
•
Supplies all voltages for the printer (+3,3 V,
+ 5 V, +12 V, -12 V, +20 V, +24 V, + 55V)
•
Connected via RS232 interface to the Devil
board, to allow saving temporary data before
switch off
DOCUMENT CONTROL NOTE:
DRYSTAR 5302
Type 5366/100
Functional Description
Agfa Company Confidentia
Chapter 2 / 20