AGFA DRYSTAR 5302 5366 Service Manual page 264

DD+DIS150.05E
2.5.4.1 Performing Film Calibrations
NOTE:
The film calibration has to be performed two times for each tray.
(1) Select menu "Service Engineer
Tools - Enter Service Command
session - 6 Calibration - 1 Film
Calibration".
(2) Select the 1
calibration film as shown in Figure
12 is printed and the measured
Dmax is shown.
INPUT TRAY:
FILM CALIBRATION OK
Dmax = 3.69 (XR310)
Measured Dmax
(3) Repeat the film calibration a 2
time.
(4) Repeat the film calibration two
times for the 2
2.5.4.2 Performing an internal Densitometer Calibration
(1) Select menu "Service Engineer Tools - Enter Service Command session - 6.
Calibration - 2. Internal densitometer calibration".
(2) Follow the instructions on the browser pages. Refer to Figure 13.
(3) Enter the measured densities in the browser window.
(4) Select "Accept changes".
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
05-2009
st
input tray: The
536736az.cdr
Default densitometer
nd
input tray.
DOCUMENT CONTROL NOTE:
DRYSTAR 5302
Adjustments and Calibrations
nd
Type 5366/100
Repair and Service
Figure 12
Chapter 3.6 / 22
Agfa Company Confidential