AGFA DRYSTAR 5302 5366 Service Manual page 36

Controls, Connections and Set Up Procedures
The reader should always refer to MedNet to ensure that they are working with the latest copy of the document.
Chapter 1 / 2
Agfa Company Confidential
Supplementary protective earth connector:
Provides a connection between the DRYSTAR 5302 and the
potential equalization busbar of the electrical system as found
in medical environments. This plug should never be
unplugged before the power is turned off and the power plug
has been removed.
Intergrounding connector:
Provides a connection between the printer and other
equipment which might exhibit minor ground potential
differences. These differences may degrade the quality of
communication between different equipment. Never remove
connections to this terminal.
Protective earth (ground)
Provides a connection between the printer and the protective
earth of the mains. Do not remove this connection, because
this will have a negative influence on the leakage current.
Power/Reset Button
Note that the power cord has to be disconnected from the wall
outlet in order to disconnect the unit entirely from the mains.
Precautions for use in USA only:
Make sure that the circuit is single-phase center-tapped, if the
printer is connected to a 240 V/60 Hz source instead of a
120 V/60 Hz source.
Transport after installation
Before moving the printer, always switch off the machine. The DRYSTAR
5302 should always be transported by 2 persons. When doing this, the
stability and the structure of the table top have to be taken into account.
The printer should not be placed on a soft surface, since this might
prevent appropriate ventilation and cause overheating. Nothing else
should be installed on the same table, and measures should be taken to
prevent table shock, while this may cause image artifacts. The appliance
shall only be transported with all covers closed. The appliance shall not be
transported continuously from one location to the other. Do not lift the
printer by the output tray.
Waste disposal and environmental regulations
In most countries DRYSTAR film is considered industrial waste and is not
allowed to be disposed of as household waste. Please consult your local
waste disposal regulations. Agfa recommends to have DRYSTAR film
waste hauled away by a licensed company.
After its life span, do not dispose of the DRYSTAR 5302 without
consideration of local waste disposal regulations. Please consult your
local service organization.
Printed copies of this document are not controlled.
Drystar 5302
(Typ 5366/100)
DD+DIS150.05E
Edition 1, Revision 0
2005-09-09