GE Vivid 3N Pro Series Service Manual page 500

GE M S
EDICAL YSTEMS
D FK091075, R
IRECTION
8-8-3-6 JVC VCR Installation Procedure
1.) Remove the white metal shelf from inside the side compartment (located on the left side of the
control console) as described on
2.) Discard the shelf.
3.) Raise the control console to its maximum height and remove the console bottom cover (upper
section) as described on
Procedure" on page
4.) Connect the VCR cables (listed below) to the appropriate sockets on the VCR rear panel (as shown
in Figure
-
-
-
-
-
5.) Connect the VCR AC power cable to the AC Input socket on the VCR rear panel (upper left corner
- not visible in
NOTE: When connecting the AC Power cable to the VCR, use the adaptor supplied with the VCR.
6.) Route all the cables through the slot at the rear of the compartment, gently pulling them in a
downwards direction. At the same time, carefully slide the VCR into the side compartment (while
feeding the cables through the slot).
7.) Check that the VCR fits properly in position and does not extend beyond the edge of the side
compartment - see
8.) Remove the protective backing from the adhesive velcro strip (supplied with the VCR) and fix the
strip firmly in position along the edge of the compartment, as shown in
Installed in Compartment" on page
NOTE: The adhesive velcro strip serves to hold the VCR securely in place whenever the Vivid 3 ultrasound
unit is moved.
8-130
04
EVISION
8-2-10-3 "Control Console Bottom Cover (Upper Section) Removal
8-17.
8-113):
Audio Input
Audio Output
Video Input (YC IN)
Video Output (YC OUT)
RS-232C
Audio Input
Audio Output
Figure 8-113 JVC VCR - Rear Connectors Panel
Figure 8-113).
Figure 8-114 "JVC VCR Installed in Compartment" on page
Section 8-8 - Peripherals
page 8-17.
8-131.
V 3N P /E S
IVID RO XPERT ERVICE
RS-232C
Video Input
Video Output
8-131.
Figure 8-114 "JVC VCR
M
ANUAL