GE Vivid 3N Pro Series Service Manual page 364

GE M S
EDICAL YSTEMS
D FK091075, R
IRECTION
7-5-8-4 iLinq IP Save/Restore
The iLinq IP Save/Restore utility, which is accessed from the System Configuration window (under the
Technical Support Tab), will allow you to save the iLinq IP settings to the hard disk, as described below.
7-5-8-4-1 iLinq IP Save Procedure:
1.) In the System Configuration window, click on the Technical Support tab - see
2.) Trackball to iLing Settings: Save and press Select. The system saves the presets to the disk.
3.) T
RACKBALL
7-5-8-4-2 iLinq IP Restore Procedure:
When required (for example, after software re-installation), you can perform Restore of iLinq IP settings
from the hard disk, as follows:
1.) From the System Configuration window (under the Technical Support Tab - refer to
above) trackball to iLinq Settings: Restore and press Select.
2.) A blank screen appears; wait for a while until the phone and modem options message is displayed
then T
3.) Wait while the restore process is running - this may take a while. When complete, a message is
displayed prompting for system shutdown.
4.) Perform a full system shutdown, then re-start the Vivid™ 3 system. The restored iLinq IP settings
will now be operational.
7-126
04
EVISION
Figure 7-99 Technical Support Tab
to OK and press Select. The scanning screen is re-displayed.
to OK and press Select.
RACKBALL
Section 7-5 - Common Service Interface
V 3N P /E S
IVID RO XPERT ERVICE
Figure 7-99
M
ANUAL
below.
Figure 7-99,