GE Vivid 3N Pro Series Service Manual page 385

GE M S
EDICAL YSTEMS
D FK091075, R
IRECTION
8-2-8-3 Bottom Keyboard Cover Removal Procedure (cont'd)
4) Lower the rear end of the bottom keyboard cover and free it from the Up/Down handle by passing
the handle through the slot on the cover, as shown
8-2-8-4 Bottom Keyboard Cover Installation Procedure
1) Raise the control console monitor to its maximum height.
2) Position the bottom keyboard cover so that the Up/Down (height adjustment) handle is correctly
aligned with the slot on the cover.
3) With one hand, lift the bottom keyboard cover upwards while using the other hand to guide the
Up/Down handle down through the slot in the cover. Push the cover all the way up to return it to its
original location (refer to
4) Return the cable hooks to their original position underneath the keyboard and fasten them securely
with their screws - refer to
page
04
EVISION
Figure 8-16 Removing the Bottom Keyboard Cover
Figure
Figure 8-15 "Removing Probe Cable Hooks under Keyboard Cover" on
8-14.
Chapter 8 Replacement Procedures
Figure 8-16
8-16, above).
V 3N P /E S
IVID RO XPERT ERVICE
below.
M
ANUAL
8-15