GE Vivid 3N Pro Series Service Manual page 382

GE M S
EDICAL YSTEMS
D FK091075, R
IRECTION
8-2-6-3 Top Cover Lower Section Removal Procedure (cont'd)
13) Remove the three screws securing the remaining section of the gas spring cover, shown below, and
lower it into the collar of the top cover.
CAUTION: The remaining section of the gas spring cover cannot be removed at this stage. Do
not attempt to remove it.
14) Remove the three screws located at the front edge of the top cover, and allow it to sink down into
the top cover collar.
15) Slightly lift the top cover, together with the remaining section of the gas spring cover, and turn them
90 degrees clockwise.
16) Keep the opened gap of the gas spring cover parallel to the opened gap of the top cover's collar,
and pull them out together in a clockwise direction.
17) Remove the gas spring cover section from the top cover.
8-2-6-4 Top Cover Lower Section Installation Procedure
1) Return the gas spring cover section back to its original position in the top cover.
2) Align the opened gap of the gas spring cover to be in parallel with the opened gap of the top cover
collar.
3) Hold the top cover and the gas spring cover section so that they are at a 90-degree angle to the
front of the unit, then insert them from the left side of the unit through their opened gap.
4) Insert and screw the three screws located at the top edge of the top cover, shown in
Cover Screws (Lower Section)" on page
5) Lift the gas cover spring cover from the top cover and fasten it with the three screws in its original
location.
6) Return the rear section of the gas spring cover to its original position and fasten it with the two
screws shown in
7) Gently fit the left and right connector panels back to their original position on the top cover and
fasten each with its four screws.
8) Mount the small section of the top cover collar, closing the open gap at the rear of the top cover,
and fasten it to the top cover with the two screws shown in
8-10.
8-12
04
EVISION
Figure 8-14 Gas Spring Cover Screws
Figure 8-14 "Gas Spring Cover Screws" on page
Section 8-2 - Cover Replacement Procedures
V 3N P
IVID
8-6.
Figure 8-11 "Top Cover Collar" on page
/E S M
RO XPERT ERVICE
Figure 8-5 "Top
8-12.
ANUAL