GE Vivid 3N Pro Series Service Manual page 449

GE M S
EDICAL YSTEMS
D FK091075, R
IRECTION
8-5-11-4 MO Drive Installation Procedure
Note: Before installing the new MO Drive, make sure the MO Drive jumper settings are shorted
as shown below:
Settings required:
A2 to B2
A9 to B9
A11 to B11
1.) For BEP1:
Assemble the black plastic slides provided with the MO drive, or use those from the drive previously
removed.
For BEP2:
Use the metal tracks provided with the MO drive, or use those from the drive previously removed.
See note below.
2) Carefully slide the MO Drive into the front of the BEP (refer to
page
For BEP2 systems, secure the MO Drive in position with the four screws (two on each side).
3) From the BEP rear, remove the empty panel (2nd from the top) and insert the SCSI card see
7-4 "SCSI Board Installation Procedure" on page
4) Connect the data cable between the SCSI card and the rear of the MO Drive.
5.) Connect the power cable to the rear of the MO Drive.
6.) If applicable, install the octopus card holder as described in
Installation Procedure" on page
7) Install the BEP left and right side covers, as described in the appropriate procedure:
8-5-2-3 "BEP1 - Left and Right Side Cover Removal Procedure" on page
Side Cover Installation Procedure" on page
Note: If this MO Drive installation is newly-installed hardware for this system, the kit should have
been provided with a set of sliders (one set for BEP1 and one for BEP2), and also a front
cover for BEP2. Refer also to the SCSI card installation instructions in
Installation Procedure" on page
04
EVISION
8-78).
Chapter 8 Replacement Procedures
8-72.
8-67.
8-64.
8-72.
V 3N P /E S
IVID RO XPERT ERVICE
Figure 8-67 "MO Drive Removal" on
8-5-3-8 "BEP2 - Octopus Card Holder
8-62, or 8-5-3-4 "BEP2 -
8-5-7-4 "SCSI Board
M
ANUAL
8-5-
8-79