GE Vivid 3N Pro Series Service Manual page 499

Table of Contents

BIOS Setup (cont'd)

5.) Use the Select button (see

MEMORY SW and then press the Set button.

6.) Using the Select and Set buttons, scroll through the various Menus and set the values for each of

the relevant Menus, in accordance with those shown in

Work in the same order as that given in

LCD display.

7.) When all the above-mentioned settings are correct, press the Menu button, select CLOCK ADJUST

and press the Set button. Using the Select and Set buttons, adjust the settings to the correct time.

When the correct time is visible in the LCD display, press the Menu button, to quit CLOCK ADJUST.

8.) Turn OFF power to the VCR. Remove the AC power cable from the mains power wall outlet and

disconnect the cable from the VCR rear panel.

If an external monitor was used for the BIOS setup procedure, turn OFF power to the external

monitor and disconnect the power cable (connected to the VCR rear panel Monitor Out - Video

socket - refer to

All settings are now stored in the VCR memory and the JVC VCR is ready for installation.

Figure 8-112 "JVC VCR Front Panel Controls" on page

JVC VCR Menu Switch Settings

S-VHS SELECT

Hi-Fi AUDIO REC.

A.DUB SELECT

RECORDING MODE

COUNTER MODE

ON SCREEN DISPLAY

AUTO TRACKING

Hi-Fi OUT AT SEARCH

NORM OUT AT SEARCH

DIRECT EJECT

MODE AT TAPE END

BAUDRATE SELECT

INFORMATION SELECT

8-4, square brackets [] indicate factory presets. The numbers in parenthesis () are seen on the

Figure 8-111 "JVC VCR - Rear Panel - External Monitor Connection" on page 8-

Chapter 8 Replacement Procedures

and do not change any settings other than those

ENHANCED (2)

[ENABLE] (1)

8-128) to select