Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
FK091075, R
IRECTION
8-6-6-4
Up/Down Handle Removal Procedure 2
NOTE:
This describes the procedure for removing the new-type (metal) Up/Down Handle.
1) Remove the bottom keyboard cover, as described in
Procedure" on page
2) Remove the right and left probe holders, as described in
Removal Procedure" on page
3) Remove the front handle from the console, as described in
Procedure" on page
4.) Release the gas spring cable by loosening the securing nut (shown in
cable out of the retaining bracket and slide the end of the cable out through the slot on the handle
assembly (see below, and refer to the detail in
Handle" on page
Handle Mounting Bracket
5.) Remove the four screws (two short and two long) that secure the handle mounting brackets to the
chassis (see
"Mounting the Brackets onto the Chassis" on page
6.) Loosen and remove the M6 nut from the handle assembly axis screw - refer to
the Up/Down Handle to the Handle Mounting Brackets" on page
7.) Extract the axis screw from the handle assembly and remove the defective Up/Down handle.
04
EVISION
8-14.
8-24.
8-103).
Handle Mounting Bracket
Figure 8-84 Up/Down Handle Securing Mechanism
Figure
8-84, above) and remove the handle assembly. Refer also to
Chapter 8 Replacement Procedures
8-2-8-3 "Bottom Keyboard Cover Removal
8-23.
Figure 8-86 "Fitting Gas Spring Cable to Up/Down
Up/Down Handle
8-103.
V
3N P
/E
IVID
RO
XPERT
8-2-12-3 "Right and Left Probe Holders
8-2-13-3 "Front Handle Removal
Figure 8-84
Gas Spring Cable
Retaining Bracket
Gas Spring Cable
Securing Nut
Figure 8-85 "Fixing
8-102.
S
M
ERVICE
ANUAL
below). Slide the
Figure 8-87
8-101
Advertisement
Table of Contents
