GE Vivid 3N Pro Series Service Manual page 429

GE M S
EDICAL YSTEMS
D FK091075, R
IRECTION
8-5-1-4 Back End Processor Installation Procedure (cont'd)
BEP Power
HASP and Parallel OUT
Do not use
Do not use
Plug & Scan, optional
Audio IN/OUT
PC2IP IN/OUT
Ext. Keyboard
6.) Connect the keyboard cable to the keyboard socket [5].
7.) Connect the cable to the COM 1 socket [6].
8.) Connect the cable to the HASP and Parallel OUT socket [7].
9.) If available on the system, connect the USB cable to the USB socket [8].
10.) If available on the system, connect the Network cable to the Network socket [9].
11.) Connect the Back End Audio BKT EXT cable to the Audio IN/OUT socket [10b].
12.) Connect the Back End Audio BKT EXT cable to the Audio IN/OUT socket [10a].
13.) Connect the PC2IP cable to the PC2IP IN/OUT socket [11].
14.) If available on the system, connect the modem communication cable to the COM 3 and 4 socket
[12].
15.) Connect the Back End KB Cont P1 cable to the Ext Keyboard socket [13b].
16.) Connect the Back End KB Cont P2 cable to the Ext Keyboard socket [13a].
17.) Connect the VIC/ Rear Panel left connector cable to the RGB Video OUT
socket [14].
18.) Connect the Keyboard/VIC External power cable to the power to Keyboard Matrix socket [15].
Note: IMPORTANT - Do NOT connect the HASP key to this socket! - refer to
[connection to socket 7].
04
EVISION
Trackball
5
Keyboard
COM1
X
8
USB
Network
Figure 8-55 Cable Connections on BEP2 Rear Panel
Chapter 8 Replacement Procedures
16a
4
1
15
2
6
14
7
9
X
3
16b
10b
10a
11
12
13a 13b
V 3N P /E S
IVID RO XPERT ERVICE
VGA OUT (to Monitor)
Power to Keyboard Matrix
RGB Video OUT
VIC VGA IN
VIC VGA OUT
Audio IN/OUT
COM3 & 4 for Modem
(only if option installed)
step 8 above
M
ANUAL
8-59