Connecting The Lift Arms To The Cutting Unit - Toro Groundsmaster 200 Operator's Manual

1. Pivot pin
2. Lift arm
5. Mount the rear of the lift arm to the lift cylinder
with a pivot pin and 2 cotter pins (supplied with
the traction unit).
6. Hook the brake return spring into the hole in the
lift arm (Figure 5).
7. Repeat this procedure for the opposite side of
the machine.
3
Connecting the Lift Arms to
the Cutting Unit
No Parts Required
Procedure
1. Move the cutting unit into position in front of the
traction unit.
2. Measure the distance from the end of each lift
arm to the center of the ball joint (grease fitting).
The distance should be 57 mm (2-1/4 inches)
(Figure 6).
Note:
If the distance is not 57 mm (2-1/4
inches), loosen the jam nut that secures the ball
joint to the lift arm and rotate the ball joint in or
out until you attain the distance. Do not tighten
the jam nuts at this time.
Figure 5
3. Lift arm pivot bracket
4. Brake return spring
g010783
1. Lift arm
2. Ball joint
3. Move the lift lever to the F
the lift arms down until the holes in the ball joint
mounts lineup with the holes in the castor arms.
Note:
For the Groundsmaster 3280–D and
3320, the engine must be running to lower the
lift arms.
4. Secure the ball joint mounts to each castor arm
with 2 capscrews (7/16 x 3 inches) and flange
nuts (7/16 inches)
1. Castor arm
2. Ball joint mount
3. Ball joint
Note:
The ball joint mount should be above the
castor arm when you assemble it.
5. Tighten the large jam nut that secures the ball
joint to the lift arm
10
Figure 6
3. Jam nut
4. 57 mm (2–1/4 inch)
position. Push
LOAT
(Figure 7).
Figure 7
4. Capscrew (7/16 x 3
inches)
5. Flange nut (7/16 inches)
(Figure 7).
g010784
g010785