Replacing An Mx240 As Mxc; Removing An Mx240 As Mxc - Juniper MX240 Hardware Manual

SEE ALSO
Preventing Electrostatic Discharge Damage to an MX240 Router | 467
MX240 Application Services Modular Storage Card Description

Replacing an MX240 AS MXC

Removing an MX240 AS MXC | 374

1.
Installing an MX240 AS MXC | 375
2.
Removing an MX240 AS MXC
AS MXCs are hot-insertable and hot-removable. When you remove an AS MXC, the router continues to
function.
The AS MXCs are located in the AS MLCs installed in the front of the router. An AS MXC weighs 1.4 lb
(0.6 kg).
To remove an AS MXC (see
1. Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the AS MXC.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
3. Use one of the following methods to take the AS MXC offline:
Press its online/offline button. Use a narrow-ended tool that fits inside the opening that leads to the
button. Press and hold the button until the AS MXC LED goes out (about 5 seconds).
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot offline
For more information about the command, see the
5. Slide the AS MXC out of the AS MLC card carrier by pulling the handles, and place it in the electrostatic
bag or on the antistatic mat.
6. If you are not reinstalling an AS MXC into the emptied AS MXC slot within a short time, install a blank
AS MXC panel over the slot to maintain proper airflow in the AS MLC card cage.
Figure 131 on page 375):
CLI Explorer.
374