Mx240 Flexible Pic Concentrator (Fpc) Leds - Juniper MX240 Hardware Manual

Figure 35: FPC Installed in the MX240 Router Chassis
SC B
SC B
FPC Components
Each FPC consists of the following components:
FPC card carrier, which includes two PIC slots.
Up to two Packet Forwarding Engines, each consisting of one I-chip for Layer 3 processing and one
Layer 2 network processor.
Midplane connectors and power circuitry.
Processor subsystem (PMB), which includes a 1.2-GHz CPU, system controller, 1 GB of SDRAM, and
two Gigabit Ethernet interfaces.
Two LEDs, located on the craft interface above the FPC, that display the status of the FPC and are
labeled OK and FAIL. For more information about the FPC LEDs located on the craft interface, see
"MX240 Component LEDs on the Craft Interface" on page
FPC online/offline button, located on the craft interface above the FPC
SEE ALSO
MX240 FPC Terminology
Replacing an MX240 FPC | 331
Maintaining MX240 FPCs | 324
Troubleshooting the MX240 FPCs | 430

MX240 Flexible PIC Concentrator (FPC) LEDs

Two LEDs, located on the craft interface above the FPC, that display the status of the FPC and are labeled
OK and FAIL. For more information about the FPC LEDs located on the craft interface, see
Component LEDs on the Craft Interface" on page
40.
40.
124
"MX240