Tools Required To Install The Mx240 Router With A Mechanical Lift; Removing Components From The Mx240 Router Before Installing It With A Lift - Juniper MX240 Hardware Manual

6. Insert the two screws at the top of the bracket and tighten each partially.
Two screws are needed for mounting the bracket on the center of the chassis. You do not need the
third screw.
7. Tighten the two screws completely.
8. Repeat the procedure for the other bracket.

Tools Required to Install the MX240 Router with a Mechanical Lift

To install the router, you need the following tools:
Mechanical lift
Phillips (+) screwdriver, number 2
7/16-in. (11 mm) nut driver
ESD grounding wrist strap
Removing Components from the MX240 Router Before Installing it with a
Lift
To make the router light enough to install, you first remove most components from the chassis. The
procedures in this section for removing components from the chassis are for initial installation only, and
assume that you have not connected power cables to the router. The following procedures describe how
to remove components from the chassis, first from the rear and then from the front:
Removing the Power Supplies Before Installing the MX240 Router with a Lift | 221
1.
Removing the Fan Tray Before Installing the MX240 Router with a Lift | 221
2.
Removing the SCBs Before Installing the MX240 Router with a Lift | 222
3.
Removing the DPCs Before Installing the MX240 Router with a Lift | 223
4.
Removing the FPC Before Installing the MX240 Router with a Lift | 224
5.
220