Juniper MX240 Hardware Manual page 325

You hold an FPC horizontally when installing it into the chassis or an equipment rack. To hold an FPC
vertically (see Figure 112 on page
1. Orient the FPC so that the faceplate faces you.
2. Place one hand around the FPC faceplate about a quarter of the way down from the top edge. To avoid
deforming the electromagnetic interference (EMI) shielding strip, do not press hard on it.
3. Place your other hand at the bottom edge of the FPC. If the FPC has heat sinks about midway between
the faceplate and connector edge, place your other hand against the heat sinks.
Figure 112: Holding an FPC Vertically
SEE ALSO
MX240 FPC Terminology
Storing an MX240 FPC | 330
329):
329