Juniper MX240 Hardware Manual page 313

NOTE: A DPC weighs 14.5 lb (6.6 kg). Be prepared to accept the full weight of the DPC as you
lift it.
To hold a DPC vertically:
1. Orient the DPC so that the faceplate faces you. To verify orientation, confirm that the text on the DPC
is right-side up and the electromagnetic interference (EMI) strip is on the right-hand side.
2. Place one hand around the DPC faceplate about a quarter of the way down from the top edge. To
avoid deforming the EMI shielding strip, do not press hard on it.
3. Place your other hand at the bottom edge of the DPC.
If the DPC is horizontal before you grasp it, place your left hand around the faceplate and your right hand
along the bottom edge.
To hold a DPC horizontally:
1. Orient the DPC so that the faceplate faces you.
2. Grasp the top edge with your left hand and the bottom edge with your right hand.
You can rest the faceplate of the DPC against your body as you carry it.
As you carry the DPC, do not bump it against anything. DPC components are fragile.
Never hold or grasp the DPC anywhere except places that this document indicates. In particular, never
grasp the connector edge, especially at the power connector in the corner where the connector and bottom
edges meet. See Figure 104 on page 318.
317