Installing An Sfp Or Xfp Transceiver Into An Mx240 Dpc, Mpc, Mic, Or Pic - Juniper MX240 Hardware Manual

CAUTION:
before reinserting it or inserting a transceiver into a different slot.
SEE ALSO
MX240 Dense Port Concentrator (DPC) Description | 113
MX240 PIC Description | 125
MX240 Modular Port Concentrator (MPC) Description | 154
MX240 Modular Interface Card (MIC) Description | 139
Replacing a Cable on an MX240 DPC, MPC, MIC, or PIC | 359

Installing an SFP or XFP Transceiver into an MX240 DPC, MPC, MIC, or PIC | 365

Preventing Electrostatic Discharge Damage to an MX240 Router | 467
Installing an SFP or XFP Transceiver into an MX240 DPC, MPC, MIC, or PIC
To install an SFP or XFP:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Take each transceiver to be installed out of its electrostatic bag, and identify the slot on the component
where it will be installed.
3. Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the transceiver with a
safety cap.
4. Carefully align the transceiver with the slots in the component. The connectors should face the
component.
5. Slide the transceiver until the connector is seated in the component slot. If you are unable to fully insert
the transceiver, make sure the connector is facing the right way.
6. Close the ejector handle of the transceiver.
7. Remove the rubber safety cap from the transceiver and the end of the cable. Insert the cable into the
transceiver.
After removing a transceiver from the chassis, wait at least 30 seconds
399