Maintaining Mx-Spc3 Services Card - Juniper MX240 Hardware Manual

Preventing Electrostatic Discharge Damage to an MX240 Router | 467
MX240 Application Services Modular Processing Card Description | 164
SEE ALSO
Preventing Electrostatic Discharge Damage to an MX240 Router | 467
MX240 Application Services Modular Processing Card Description | 164

Maintaining MX-SPC3 Services Card

IN THIS SECTION
Maintaining MX-SPC3 Services Card | 377
Replacing an MX-SPC3 | 378
Maintaining MX-SPC3 Services Card
Purpose
For optimum router performance, verify the condition of the MX-SPC3 Services Card. To maintain
MX-SPC3s cards, perform the following procedures regularly.
Action
On a regular basis:
Check the LEDs on the craft interface corresponding to the slot for each MX-SPC3. The green LED
labeled OK lights steadily when a MX-SPC3 is functioning normally.
Check the OK/FAIL LED on the MX-SPC3. If the MX-SPC3 detects a failure, the MX-SPC3 sends an
alarm message to the Routing Engine.
Issue the CLI show chassis fpc command to check the status of installed MX-SPC3s.
user@host> show chassis fpc
For more detailed output, add the detail option.
377