Storing An Mx240 Dpc - Juniper MX240 Hardware Manual

If you must rest the DPC temporarily on an edge while changing its orientation between vertical and
horizontal, use your hand as a cushion between the edge and the surface.
SEE ALSO
MX240 DPC Terminology

Storing an MX240 DPC | 319

Troubleshooting the MX240 DPCs | 429
Replacing an MX240 DPC | 320
Storing an MX240 DPC
You must store a DPC as follows:
In the router
In the container in which a spare DPC is shipped
Horizontally and sheet metal side down
When you store a DPC on a horizontal surface or in the shipping container, always place it inside an
antistatic bag. Because the DPC is heavy, and because antistatic bags are fragile, inserting the DPC into
the bag is easier with two people. To do this, one person holds the DPC in the horizontal position with the
faceplate facing the body, and the other person slides the opening of the bag over the DPC connector
edge.
If you must insert the DPC into a bag by yourself, first lay the DPC horizontally on a flat, stable surface,
sheet metal side down. Orient the DPC with the faceplate facing you. Carefully insert the DPC connector
edge into the opening of the bag, and pull the bag toward you to cover the DPC.
Never stack a DPC under or on top of any other component.
SEE ALSO
MX240 DPC Terminology
Holding an MX240 DPC | 316
Troubleshooting the MX240 DPCs | 429
319