Mx240 Management And Console Port Specifications And Pinouts; Rj-45 Connector Pinouts For An Mx Series Routing Engine Ethernet Port - Juniper MX240 Hardware Manual

Table 88: Cable and Wire Specifications for Routing Engine and RCB Management and Alarm
Interfaces (continued)
Cable
Port Specification
Routing Engine Category 5
Ethernet cable or
interface equivalent
suitable for
100Base-T
operation
Alarm relay Wire with
contacts gauge between
28-AWG and
14-AWG (0.08
and 2.08 mm
MX240 Management and Console Port Specifications
and Pinouts
IN THIS SECTION

RJ-45 Connector Pinouts for an MX Series Routing Engine ETHERNET Port | 205

RJ-45 Connector Pinouts for MX Series Routing Engine AUX and CONSOLE Ports | 206
RJ-45 Connector Pinouts for an MX Series Routing Engine ETHERNET Port
The port on the Routing Engine labeled ETHERNET is an autosensing 10/100-Mbps Ethernet RJ-45
receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or
other device that supports out-of-band management).
pinout.
Cable/Wire Maximum
Supplied Length
One 4.57-m 100 m
length with
RJ-45/RJ-45
connectors
No None
2
)
Table 89 on page 206
Router
Receptacle
RJ-45
autosensing
—
describes the RJ-45 connector
205