SPEEDOMETER VS SENSOR
SYSTEM INSPECTION
Check the combination meter functions properly.
If they do not function, perform the power and ground line
inspection of the combination meter (page 17-5).
Remove the dust cover.
Check the connection/connector for correct fitment.
VEHICLE SPEED SENSOR
Disconnect the VS sensor 3 connectors.
Turn the ignition switch to ON and measure the voltage
between the Black (+) and Green (–) wire terminals at the
harness side.
CONNECTION:
STANDARD:
If there is no voltage, check for open circuit in related wires.
If voltage is as per specification, check the VS sensor as
follows.
Measure the voltage between the White/Blue (+) and
Green(–) wire terminals of the sensor side connector.
Slowly turn the rear wheel by hand.
There should be 0 to 5 V pulse voltage.
If pulse voltage does not appear, replace the VS sensor.
Black (+) – Green (–)
9 ± 0.5 V
LIGHTS/METERS/SWITCHES
16P CONNECTOR
3 WIRE CONNECTOR
DUST COVER
HARNESS SIDE
VS SENSOR SIDE
17-7