Honda CB HORNET 160R 2015 Shop Manual page 142

CLUTCH/GEARSHIFT LINKAGE
Rotate the lifter arm in anti clockwise direction then pull
out the clutch lifter arm from the right crankcase cover, and
remove the return spring.
Remove the kick starter spindle dust seal.
Remove the clutch lifter arm and dust seal.
Check the clutch lifter arm for wear or damage.
Check the return spring for fatigue or damage.
Replace them if necessary.
ASSEMBLY
Apply grease to a new kickstarter spindle dust seal lip and
install it into the right crankcase cover.
Apply grease to a new clutch lifter arm dust seal lip and
install it into the right crankcase cover.
Apply clean engine oil to the clutch lifter arm sliding surface,
and install it into the right crankcase cover.
Install the return spring onto the lifter arm groove and
and rotating the lifter arm in clockwise direction.
Hook the return spring ends as shown.
9-4
CLUTCH LIFTER ARM
DUST SEAL
CLUTCH LIFTER ARM
DUST SEAL
CLUTCH LIFTER ARM
RETURN SPRING
LIFTER ARM
GROOVE