Honda CB HORNET 160R 2015 Shop Manual page 164

ALTERNATOR
Check the dust seal and needle bearing in the front cover
for deterioration, wear or damage.
Check for continuity between the cable terminal and the
insulated brush.
There should be continuity.
Check for continuity between the cable terminal and rear
cover.
There should be no continuity.
Remove the following:
– Springs
– Screw/washers
– Brush wire
– Brush holder
10-10
NEEDLE BEARING
SPRINGS
SCREWS/
WASHER
DUST SEAL
BRUSH
HOLDER
BRUSH
WIRE