Honda CB HORNET 160R 2015 Shop Manual page 208

FRONT WHEEL/SUSPENSION/STEERING
BRAKE DISC
ALLEN BOLT
42 N.m (4.3 kgf.m, 31 lbf.ft)
Never install the Pack all bearing cavities with grease.
old bearing once
Drive in a new left bearing squarely with its sealed side
the bearing has
facing up until it is fully seated.
been removed,
the bearing must Install the distance collar, then drive in a new left bearing
squarely with its sealed side facing up.
be replaced with
new ones.
TOOLS:
Driver
Attachment, 42 x 47 mm
Pilot, 15 mm
Do not apply Install the brake disc onto the brake hub with the arrow
grease on the mark facing out.
brake disc or
Install and tighten new brake disc mounting bolts to the
stopping power
specified torque in a crisscross pattern in 2 or 3 steps.
will be reduced
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
Apply grease to a new right dust seal lip.
Install the dust seal until it is flat surface with the right
wheel hub.
12-12
DUST SEAL
SIDE COLLAR
07749-0010000
07746-0010300
07746-0040300
BEARING
DISTANCE COLLAR
ATTACHMENT
BRAKE DISC
DUST SEAL
BEARING
DUST SEAL
SIDE COLLAR
DRIVER
PILOT
BOLTS