Clutch - Honda CB HORNET 160R 2015 Shop Manual

CLUTCH/GEARSHIFT LINKAGE

CLUTCH

REMOVAL
Remove the following:
– Right crankcase cover (page 9-3)
– Oil filter rotor cover (page 3-12)
Install the gear holder between the primary drive and driven
gears as shown, and loosen the oil filter rotor lock nut using
lock nut wrench.
TOOLS:
Gear holder
Remove the lock nut, lock washer and oil filter rotor.
Loosen the clutch lifter plate bolts (3 nos.) in a crisscross
pattern in several steps. Separate.
Remove the bolts, clutch lifter plate and clutch springs.
Attach the clutch center holder to the pressure plate using
four clutch lifter plate bolts to hold the clutch center, then
loosen the clutch center lock nut using the special tool.
TOOL:
Clutch center holder 070SRTKSP011
9-6
07006-KRBT900
LOCK NUT WRENCH
LOCK NUT
LIFTER PLATE
BOLTS
CLUTCH CENTER HOLDER
GEAR HOLDER
LOCK NUT
OIL FILTER ROTOR
WASHER
SPRINGS
LOCK NUT