Combi Brake System; Cbs Brake Line; Rear Brake Line; Brake Fluid Filling/Air Bleeding Front Brake - Honda CB HORNET 160R 2015 Shop Manual

BRAKE SYSTEM

COMBI BRAKE SYSTEM:

Do not allow
Combine brake system (page 14-3) consist of two individual
foreign material
hydraulic circuit, the front brake line and CBS line.
to enter the
• Front brake line - Draining procedure same as front
system when
brake non CBS
filling the
• CBS brake line & Rear brake line - Follow the below
reservoir.
process:
When using a

CBS BRAKE LINE:

commercially
available
Remove the right side cover (page 2-3).
brake bleeder,
follow the
Remove the mounting bolt of brake fluid reservoir. Remove
manufacture's
reservoir cover screw, reservoir cover, set-plate and
operating
diaphragm.
instructions.
Connect the bleed hose to the CBS bleed valve of the
front brake caliper.
Loosen the bleed valve and pump the rear brake padel
until no more fluid flows out of the bleed valve.
Tighten the bleed valve.

REAR BRAKE LINE:

Connect a bleed hose to the rear brake caliper bleed valve.
Loosen the bleed valve and pump the rear brake pedal
until no more fluid flows out of the bleed valve.
Tighten the bleed valve.
BRAKE FLUID FILLING/AIR BLEEDING
FRONT BRAKE (DISC):
If a brake bleeder/automatic refill system is available
then use the following steps:
Connect the automatic refill system to the reservoir, follow
Do not mix
the manufacturer's operation instruction.
different types of
fluid. These are
Connect the commercially available brake bleeder to the
not compatible
front caliper bleed valve.
Perform the bleeding procedure until the system is
completely flushed/ bleed.
After bleeding the air completely, tighten the brake caliper
bleed valve to the specified torque.
TORQUE: 5.4 N.m (0.6 kgf.m, 4.0 lbf.ft)
14-4
SCREWS
RESERVOIR COVER
CBS BLEED VALVE
BLEED HOSE
BLEED HOSE
FRONT MASTER CYLINDER
SET PLATE/
DIAPHRAGM
BLEED VALVE