Rear Brake Disc Inspection - Honda CB HORNET 160R 2015 Shop Manual

BRAKE SYSTEM
INSTALLATION
Install new brake pads so that their ends rest on the caliper
bracket properly.
Install new O-ring on to the pad pin groove and apply
silicone grease
Install the brake pad pin by pushing the pads against the
pad spring to align the pad pin holes in the pads and caliper.
Drive the pad pin into the caliper.
Tighten the rear brake pad pin to the specified torque.
TORQUE:17.2 N·m (1.7 kgf·m, 12 lbf·ft)

REAR BRAKE DISC INSPECTION

Visually inspect the brake disc for damage or cracks.
Measure the brake disc thickness at several points.
SERVICE LIMIT : 3.5 mm (0.14 in)
Replace the brake disc if the smallest measurement is less
than service limit.
Check the brake disc warpage using a dial indicator.
SERVICE LIMIT : 0.10 mm (0.004 in)
14-20
BRAKE PAD
REAR BRAKE
PAD PIN
O- RING
PAD PIN