Install the master cylinder bracket & holder with "UP" mark
facing up.
Aligning the mating surface of the bracket holder with the
punch mark on the handle bar.
Tighten the holder bolt to the specified torque.
TORQUE: 9 N.m (0.9 kgf.m, 6.6 Ibf.ft)
Also connect the front brake light switch connector.
Install the wire bands and rear view mirrors.
Tighten the mirror mounting nuts to the specified torque.
TORQUE: 34 N.m (3.5 kgf.m, 26 Ibf.ft)
Check & adjust the throttle grip free play (Page 3-5).
Adjust the clutch lever free play (Page 3-22).
FRONT WHEEL
REMOVAL
Tie down the ve-
hicle from rear
Loosen the front axle nut.
side by using tie
Support the motorcycle using a safety stand or hoist, raise
down belt.
the front wheel off the ground.
Remove the front axle nut.
FRONT WHEEL/SUSPENSION/STEERING
MASTER CYLINDER
BOLTS
CONNECTORS
REARVIEW MIRROR
ADAPTOR
WIRE BAND
"UP" MARK
HOLDER
AXLE NUT
12-9