Rear Master Cylinder Assembly - Honda CB HORNET 160R 2015 Shop Manual

BRAKE SYSTEM
Remove the push rod assembly, master piston and spring.
Clean the inside of the cylinder with clean brake fluid.
INSPECTION
Check the piston boot, primary cup and secondary cup
for fatigue or damage.
Check the master cylinder and piston for abnormal
scratches.
Measure the master cylinder I.D
SERVICE LIMIT:
CBS: 12.775 mm (0.5029 in)
Measure the master cylinder O.D
SERVICE LIMIT:
CBS: 12.645 mm (0.4978 in)

REAR MASTER CYLINDER ASSEMBLY

NOTE:
Replace the piston, spring and cup as a set.
MASTER
CYLINDER CAP
DIAPHRAGM PLATE
14-22
DIAPHRAGM
OIL CUP COMP.
MASTER PISTON
SCREW
HOSE JOINT
O-RING
SCREW/ WASHER
SPRING
PUSH ROD ASSEMBLY
SPRING
MASTER CYLINDER
SNAP RING
BOOT
NUT
BRAKE ROD JOINT
MASTER PISTON
PUSH ROD