Honda CB HORNET 160R 2015 Shop Manual page 315

2. Fuel Level Sensor Output Line Inspection
Remove the right side cover (page 2-3).
Check the continuity between the fuel level sensor
2P (White) connector terminal and wire harness side of
the combination meter.
CONNECTION:
Yellow/White – Yellow/White
Green – Green
Is there continuity?
NO – Open circuit in Yellow/White or Green wire
YES – Check the Speedometer.
REMOVAL/INSTALLATION
Drain the fuel from the fuel tank into the approved gasoline
container.
Remove the fuel tank (page 2-3).
Remove the nuts (4 nos.) .
Remove the fuel level sensor unit and O-ring.
Install a new O-ring to the fuel tank.
Be careful not
to damage the
Install the fuel level sensor unit into the fuel tank.
float arm.
LIGHTS/METERS/SWITCHES
2P CONNECTOR
FUEL LEVEL SENSOR UNIT
FUEL LEVEL
SENSOR UNIT
FUEL LEVEL
SENSOR UNIT
NUTS
FLOAT
O-RING
FLOAT
O-RING
17-15