Honda CB HORNET 160R 2015 Shop Manual page 51

Remove the gasket from the oil rotor cover.
While pressing the oil through from the reverse side, then
remove the clip.
Remove the oil through and spring from the oil filter rotor
cover.
Blow and clean the oil through using compressed air.
Apply clean engine oil to the oil through surface, and install
the spring and oil through to the oil filter rotor cover.
While pressing the oil through from the reverse side, install
the clip.
Check the oil through operates freely, without binding.
Install a new gasket on to the oil rotor cover.
Install and tighten the oil filter rotor cover screws by using
gear holder between clutch gear and Gear Primary Drive.
TORQUE: 4 N·m (0.4 kgf·m, 3.0 lbf·ft)
Install the right crankcase cover (page 9-5).
OIL THROUGH
OIL FILTER ROTOR CAP
SPRING
OIL THROUGH
COVER/GASKET
MAINTENANCE
CLIP
COVER/GASKET
OIL THROUGH
CLIP
COVER/GASKET
SCREWS
3-13