Crankshaft/Balancer Bearing Inspection; Big End Side Clearance; Big End Radial Clearance; Timing Sprocket - Honda CB HORNET 160R 2015 Shop Manual

BIG END SIDE CLEARANCE

Measure the side clearance of the connecting rod big end
with feeler gauge.
SERVICE LIMIT:

BIG END RADIAL CLEARANCE

Measure the radial clearance of the connecting rod big end.
SERVICE LIMIT:

TIMING SPROCKET

If the timing
sprocket teeth
Check the timing sprocket teeth for wear or damage.
are worn or
damaged. Remove the timing sprocket if necessary.
Check the cam
When installing the timing sprocket, while align the center
chain
of the timing sprocket teeth with the center of the crank pin.
tensioner and
cam sprocket
CRANKSHAFT/BALANCER BEARING
INSPECTION
Turn the inner of each bearing with your finger. The
bearings should turn smoothly and quietly.
Also check that bearing outer races fit tightly in the
crankcase.
Replace bearing if the inner race do not turn smoothly,
quietly or if they loosely fit in crankcase (page 11-10).
0.80 mm (0.032 in)
0.05 mm (0.002 in)
CRANKCASE/TRANSMISSION/KICKSTARTER
TIMING SPROCKET
CRANK PIN
11-9