ALTERNATOR
Install the insulator plates.
Install the brush holder, washer and tighten the screws
with brush wire.
Install the springs into the brush holder.
Install the shims onto the armature shaft.
Install the shims properly as noted during removal.
Be careful not
to damage the
Apply a thin coat of grease to the armature shaft end.
brush and
Install the brushes into the brush holder.
armature.
Spread the brushes.
Install the armature into the rear cover assembly.
Install a new seal ring to the motor case.
10-14
INSULATOR
SPRINGS
SCREWS/
WASHER
BRUSHES
BRUSH
HOLDER
BRUSH
WIRE
SHIMS
ARMATURE