Honda CB HORNET 160R 2015 Shop Manual page 256

BRAKE SYSTEM
INSTALLATION
Apply clean brake fluid to the master piston.
Install the spring onto the piston end, and install it into the
master cylinder.
Be certain the
Install the snap ring into the groove in the master cylinder.
snap ring is
firmly seated
in the groove
Apply grease to boot and install it to the master cylinder.
NOTE:
If seal is found damage replace the master cylinder piston
set.
Install the brake light switch to the master cylinder by
aligning the brake light switch boss with master cylinder
hole.
14-12
MASTER CYLINDER
SPRING
MASTER PISTON
BOOT
BOOT
SNAP RING
BRAKE LIGHT
SWITCH
ALIGN