Swingarm - Honda CB HORNET 160R 2015 Shop Manual

INSTALLATION
Shock absorber
shall be installed
Install the shock absorber.
with adjust label
right side.
Install the upper mounting nut and bolt.
TORQUE: 44 N.m (4.5 kgf.m, 33 Ibf. ft)
Install the lower bolt and nut.
Tighten the lower mounting nut to the specified torque.
TORQUE: 44 N.m (4.5 kgf.m, 33 Ibf. ft)
Install the following:
– Fuel tank (page 2-3)
– Drive chain case (page 13-0)
– Rear wheel (page 13-8)

SWINGARM

Remove the rear wheel (page 13-4).
Remove the mounting bolts (4 nos.) and drive chain upper
and lower case
For Disc type:
Remove the rear brake calliper hose mounting
bolts (2 nos.) and carefully hold the brake calliper slider.
REAR WHEEL/SUSPENSION
MOUNTING NUT
NUT
DRIVE CHAIN
UPPER CASE
DRIVE CHAIN
LOWER CASE
REAR BRAKE
HOSE
BOLT
SHOCK ABSORBER
BOLT
BOLTS
BOLTS
13-13