Honda CB HORNET 160R 2015 Shop Manual page 151

CLUTCH/GEARSHIFT LINKAGE
Remove the following:
RETURN SPRING
– Dowel pins from the shift drum
– Stopper arm bolt
DOWEL PINS
– Stopper arm
– Washer
– Return spring
WASHER
STOPPER ARM
BOLT
INSPECTION
Check the gearshift spindle for wear or bend.
Check the spindle plate for wear, damage or deformation.
RETURN SPRING
Check the return spring for fatigue or damage.
GEARSHIFT SPINDLE
PLATE
INSTALLATION
RETURN SPRING
Apply locking agent to the stopper arm bolt threads.
Install the return spring, washer, stopper arm and bolt, and
tighten the bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
WASHER
HOOK
Hook the return spring to the stopper arm groove.
STOPPER ARM
BOLT
Install the dowel pins into the shift drum hole.
STOPPER ARM
Hold the stopper arm using a special tool and install the
gearshift cam, while aligning the pins hole with the dowel
Align
pins.
TOOL:
Holder gear drum stopper arm: 070SRTKSP010
GEARSHIFT CAM
9-13