Swingarm - Honda Hawk GT NT650 1988 Service Manual

Route and clamp the shock absorber drain tube.
Install the shock absorber lower mounting bolt.
TORQUE: 45 N·m {4.5 kg-m, 33 ft-Ibl
SWINGARM
REMOVAL
Raise the rear wheel off the ground by placing the motorcycle
on its center stand.
Remove the rear wheel (page 13-3) and eccentric bearing car-
rier (page 13-6).
Remove the shock absorber lower mounting bolt.
Remove the swingarm pivot nut.
Unhook the rear brake hose and remove the rear brake caliper
(page 14-15).
REAR WHEEL/SUSPENSION
/
;
.
Loosen the lock nut and remove it.
Do not pull the swingarm pivot bolt out at this time.
TOOL:
lock nut wrench
07908 - ME90000
Using a hex wrench, turn the pivot bolt and adjusting bolt
counterclockwise together.
13-19