Configuring the switch using ACLI
Enabling or disabling SNTP
Enable or disable Simple Network Time Protocol . The default value for SNTP is Disabled.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command (without the optional [no]
Variable definitions
The following table describes the parameters for the sntp enable command.
no
Setting SNTP server primary secondary address
Set or clear the IP address for the primary or secondary NTP server.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
Variable definitions
The following table describes the parameters for the sntp server <primary|secondary>
address command.
<A.B.C.D>
56
Getting Started
parameter to enable SNTP:
[no] sntp enable
Variable
[no] sntp server <primary|secondary> address <A.B.C.D>
Variable
Comments? infodev@avaya.com
Value
Disables SNTP
Value
Enter the IP address of the primary or
secondary NTP server in the format
XXX.XXX.XXX.XXX.
March 2013