Engineering in PAA
14.15 Engineering in the function diagram
Procedure
1. Select the "Symbol table > Import symbol table" command in the context menu of the symbol
table.
2. In the file system you select the symbol table from which you want to import the symbolic
addresses.
See also
Refreshing the symbol table (Page 146)
14.14.3
Refreshing the symbol table
Procedure
To refresh all symbolic addresses in the symbol table, select the command "Symbol table >
Refresh symbol table" from the shortcut menu of the symbol table below the station.
Result
The symbolic addresses are written into the symbol table.
14.15
Engineering in the function diagram
14.15.1
Editing control modules on the function diagram
Requirement
● The function diagram is open.
● The control module was automatically placed on the function block diagram during the
import or during the creation in the "Type configurator" plugin.
See chapter Importing control modules and equipment modules (Page 180) and
chapter Creating control modules (Page 26).
146
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA