Software Engineering In The Navigator; Notes On The Plant Hierarchy - Siemens SIMATIC PCS 7 Operating Manual

Note
Standard values in the export
When using the extended hardware parameters, the standard values are not transferred. If you
wish to use the standard values from PCS 7, carry out an import from PCS 7.
Note
No automatic consistency check of the hardware configuration
In PAA, no consistency check of the set HW parameters is carried out. This has the result that
configurations can be transferred which are inconsistent in SIMATIC HW Config.
Note
Inconsistencies during channel assignment
In PAA, the limits for channel 0 (channel groups 0-1) are correct in channel 0.
For channel 2 (channel groups 2-3), contrary to the assignment in PCS 7, the limits in PAA are
on channel 1. The limits on channel 1 are transferred to PCS 7 for channel 2 (channel group
2-3).
14.11

Software engineering in the Navigator

14.11.1

Notes on the plant hierarchy

Requirement
● The project presetting for PCS 7 is used.
See chapter Opening a planning project (Page 22).
● The DCS structure has been created.
See chapter Creating the DCS structure (Page 22).
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA
14.11 Software engineering in the Navigator
Engineering in PAA
133