Siemens SIMATIC PCS 7 Operating Manual page 191

● Slave label is displayed and it is editable.
● The slave assembly plan can be opened via comos standard functionality.
Right-click on the slave > "Navigate" > "Documents below" > "Assembly plan".
Note
● The assembly plan is not available for the ET 200SP slave
● Two PS are displayed for ET 200iSP as standard, irrespective of the power supply type
Note
IOs are only static images and not the exact configuration.
Common functionalities for S7 400 stations
The new intelligent and dynamic symbols for the S7400 stations have the following
functionalities:
● CPU / CP can be selected and navigated to its object
Right-click on the CPU / CP > "Navigate" > "Object".
● For PROFIBUS and Ethernet, the connectors available under the CPU / CP can be collected
dynamically and displayed
If a second CP is added or removed for the station, the symbols will be changed dynamically.
● Station label is displayed and it is editable
● The station assembly plan can be opened via COMOS standard functionality
Right-click on the station label > "Navigate" > "Documents below" > "Assembly plan".
Note
IO modules are not displayed in the station's configuration plan. Only PS / CPU / CP stations
are displayed.
An identification for the subtype (Green for Ethernet and Purple for PROFIBUS) is provided at
each connector. Connections can be made only for the same subtype.
Size of the single station is dynamic. On the other hand, size of the redundant station is fixed
even if no CPs are placed.
Note
On same configuration plan, displaying the symbols for multiple similar Station/Slave is not
handled.
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA
(single or redundant)
Working with reports
19.5 Configuration plan
191