Configuring A Simatic Station - Siemens SIMATIC PCS 7 Operating Manual

The example looks like this in the Topology editor of PCS 7:
14.7.3

Configuring a SIMATIC station

Requirement
● The "Locations" tab is displayed in the Navigator.
● A plant has been created.
Creating a SIMATIC station
1. Select the object "Plant > Building > Floor, level > Room, Control center".
2. Select the "New > Cabinet" command from the context menu of the room.
The cabinet is created below the room.
3. Select the "New > Station > <required station>" command in the context menu of the cabinet.
The station is created below the cabinet.
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA
14.7 Hardware engineering in the Navigator
Engineering in PAA
107