Configuring The Central Processing Unit (Cpu) - Siemens SIMATIC PCS 7 Operating Manual

Engineering in PAA
14.7 Hardware engineering in the Navigator
Equipping a SIMATIC station with hardware
1. Select the station in the Navigator.
2. Select the "New > > Rack <required rack>" command in the shortcut menu of the station.
The rack is used to mount the assemblies.
3. Select the required power supply under "New > Power supply" in the shortcut menu of the
rack.
4. Select a central processing unit (CPU) under "New > Central processing units" in the
shortcut menu of the rack.
– Each central processing unit is equipped with at least one submodule. The submodule
– Depending on the central processing unit: Create further modules under the CPU if
5. Select an input module from one of the following folders under "New" in the shortcut menu
of the rack:
– "Digital electronic modules"
– "Analog modules"
– "Communication"
– "Function modules"
6. Select an output module corresponding to the input module from one of the following folders
under "New" in the shortcut menu of the rack:
– "Digital electronic modules"
– "Analog modules"
– "Communication"
– "Function modules"
7. If necessary, assign the rack to the location where it should be assembled.
See also
Equipping interface modules with I/O modules (Page 110)
14.7.4

Configuring the central processing unit (CPU)

Requirement
● A SIMATIC station has been created and equipped with hardware.
● In the rack, at least one central processing unit (CPU) is created.
See chapter Configuring a SIMATIC station (Page 107).
● The "Locations" tab is displayed in the Navigator.
108
is created automatically in addition.
See also chapter Configuring the central processing unit (CPU) (Page 108).
required; for example, an interface module for a bus system.
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA