Displaying The Sw Interface Tab And Creating Tasks - Siemens SIMATIC PCS 7 Operating Manual

See also
Displaying the SW interface tab and creating tasks (Page 137)
14.12.2

Displaying the SW interface tab and creating tasks

Requirement
● Software engineering has been performed.
See chapter Software engineering in the Navigator (Page 133).
● The "Units" tab is open in the Navigator.
Displaying the "SW interface" tab
1. Select a folder of the DCS structure in the "Units" tab in the Navigator.
2. Open the properties of the folder.
3. Select the "Tasks" tab.
4. If the "SW interface" tab is not available, close the folder properties window.
5. Select "New > "CMT template" in the folder context menu.
6. Open the properties of the folder.
The "SW interface" tab opens.
Checking and creating tasks
1. Select the "Tasks > SW interface" tab.
2. Check whether the following engineering task is available:
– "Assigned station"
3. Create missing task using the "New" context menu.
See also
Assigning a control module type to the DCS structure (Page 138)
Assigning a control module type to a function (Page 139)
Engineering tasks (Page 136)
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA
14.12 Editing software engineering using engineering tasks
Engineering in PAA
137