Engineering in PAA
14.7 Hardware engineering in the Navigator
3. Select the "New > desired objects" from the context menu of the mounting rail as shown in
the image below.
Note
The right mouse structure is only located under the rail/rack, not at the terminal modules or
interface module.
4. After addition of all the desired objects, to create additional objects (For example, terminal
module or carrier module or terminal block or active bus), click "Create bus modules" on the
context menu of the ET 200 station as shown in the image below.
Note
If "Create bus modules" command is executed, the additional objects are created in the
correct structure.
102
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA