Example Of An Assignment; Adopting A Mapping Table As A Template - Siemens SIMATIC PCS 7 Operating Manual

Linking attributes from PAA and PCS 7

16.4 Adopting a mapping table as a template

16.3

Example of an assignment

Requirement
● The mapping table of the signal designations is open.
See chapter Configuring the mapping table of the signal designations (Page 159).
Procedure
The following mapping applies based on the example in this documentation:
PCS 7 attribute, "Y30T00001 Automation Interface" tab
Name of the signal:
Attribute "Name Signal name"
Name of the control module:
Attribute "Name Name"
See also
Adopting a mapping table as a template (Page 162)
16.4 Adopting a mapping table as a template
Requirement
● The mapping table of the signal designations is configured.
See chapter Configuring the mapping table of the signal designations (Page 159).
● The "Units" tab is open in the Navigator.
Objective
The mapping table is saved in the templates and is then available for all control modules of this
type.
Calling a mapping table
1. In the unit structure, navigate to the inserted control module below a position.
2. In the properties of the control module, select the "Attributes > Automation Interface" tab.
162
PAA attribute
Process tag, "A20 Signal engineering" folder, properties of
the signal:
"Y00T00027 Signal data" tab, "Y00A00555 Signal descrip‐
tion" attribute
Linked through unit pointer
Item:
"Y30T00001 Automation Interface" tab, "Name Hierarchy
name" attribute
Linked through unit pointer
Operating Manual, 04/2019, A5E46351208-AA
Plant Automation Accelerator 3.0