Importing Hardware (Hw) - Siemens SIMATIC PCS 7 Operating Manual

4. To add different spellings for the same Unit, for example "m
the steps below:
– Navigate to System tables Y10|X01|A10|X01N00024 Unit mapping COMOS PCS 7.
– Navigate to the value "A240" and add a value in the column "Value 4" using the delimiter
Note
1. When a change in the unit standard table is required for all engineering projects, then it
2. User can give units in any format (like PCS7 Unit ID or COMOS unit ID or COMOS unit
3. If Mapping label is missing for CM variant, then Mapping label will be checked for master
4. Channel implementation of the signal is performed in case the IO channel information is
5. Click "Import".
The Unit with modified text will also be imported and the corresponding COMOS unit is set
on the "Measurement range" attribute of a signal from the CM instance.
Result
The CMs with all the signals and corresponding units are imported.
13.8

Importing hardware (HW)

Purpose
To configure and import the HW objects with PROFIBUS (for example, ET 200 stations) to the
UnspecifiedHW folder. All the ET 200 stations (for example, ET 200M, ET 200iSP, ET 200PA
SMART, ET 200SP HA and ET 200SP) can be imported and as an example only ET 200M is
described in this section. The user can move the slaves to the different cabinets after the first
import. But after the second import, the slaves will be still identified due to subnet connection.
Depending on the MLFB of the Interface module, the corresponding slave object will be
created. So the user can configure and create different HW objects in bulk and engineering is
done faster.
The following configurations for PROFIBUS are possible while importing the HW:
● Single configuration (1 subnet)
● Single configuration (1 subnet) with redundant slots
● Single configuration (1 subnet), 2 redundant slots on 2 IO stations
Plant Automation Accelerator 3.0
Operating Manual, 04/2019, A5E46351208-AA
";", for example, m ;m2.
2
has to be done in the base project. When a change in the unit standard table is specific
to one engineering project, then the unit Standard table should be checked into current
engineering project to modify or add the unit values in a unit standard table.To do this,
navigate to Administrator > Base data > Standard tables and select "Check into current
project" from the context menu of the "X01N00024 Unit mapping COMOS PCS 7".
text) in the excel file, for example, "m
"1023" (PCS7 Unit ID) or "I10.AA120" (COMOS unit ID).
CM template.
given for a particular signal in excel file.
13.8 Importing hardware (HW)
can be written as m2", follow
2
" can be written as "m2" (COMOS unit text) or
2
Excel import plugin
83